Arborist Measuring a Mature Arlington Oak

Arlington Tree Removal Permit: Rules, Fees and Exemptions

In Arlington, Texas, you need a Tree Removal Permit to take out a tree that measures 6 inches or more in diameter, measured 4.5 feet above the ground. That applies when there is no site plan or commercial permit attached to the work. The big exception for homeowners: no permit and no mitigation is required on a lot under one acre that has an occupied residential structure. If you live in Collin County, Arlington’s code does not govern your property at all, because Arlington sits in Tarrant County and your own city sets your rules. Below is how Arlington’s process works, what it costs, and how to check the rules where you live.

Texas Tree Transformations
Get Arborist Insight Before Tree Work
Texas Tree Transformations offers ISA Certified Arborist assessments and tree removal services for Dallas-area property owners considering regulated tree work.

TL;DR

  • Arlington requires a Tree Removal Permit for trees 6 inches or larger in diameter (at 4.5 feet above grade) when no site plan or commercial permit covers the work.
  • Lots under one acre with an occupied residential structure are exempt from the permit and from mitigation.
  • Fees in the fee schedule effective October 1, 2025: $10 per tree for a permit (minimum $30, maximum $150), $200 per caliper inch for tree replacement, and $600 per caliper inch for unauthorized removal.
  • Arlington’s rules stop at the city limits. Collin County owners need to check with their own city or county before cutting a regulated tree.
  • A certified arborist can document species, size and condition before a permit application or a removal.

Table of Contents

What the Arlington rule actually says

Arlington regulates trees through its Unified Development Code. The City’s Zoning and Unified Development Code page says a Tree Removal Permit is required when trees measuring 6 inches in diameter or larger, measured 4.5 feet above grade, are removed or adversely affected and there is no associated Site Plan or Commercial Permit.

Three phrases in that sentence trip people up.

“Adversely affected.” The rule is not only about cutting a tree down. Damaging a protected tree, for example by trenching through its roots or grading over them, can fall under the same rule. That matters for anyone building a patio, a pool or a driveway near a mature tree.

“Protected.” The City’s code defines a protected tree as any existing tree of at least six caliper inches that is not on the prohibited tree list in the UDC User’s Guide, according to the same City page. Prohibited species are the ones the City does not want to preserve, so they can come out without the same process.

“No associated Site Plan or Commercial Permit.” When you are building, the tree work is handled through that approval instead. Builders and developers deal with tree preservation plans, not stand-alone removal permits.

What the Arlington rule actually says

How trunks are measured

Measure the trunk at 4.5 feet above the ground. For multi-trunk trees the City’s Tree Removal Permit Application uses an average: take the full measurement of the largest trunk and half of each of the others. Its own example is a 6-inch, a 3-inch and a 1-inch trunk, which add up to 8 inches to mitigate.

Trunk measurement height and multi-stem calculation

This is where a misjudged measurement causes trouble. A tree that looks like a modest crape myrtle or a clump-form elm can add up to more than you expect. Wrap a tape around it at the right height and write down every trunk before you decide anything.

The exemption most Arlington homeowners fall under

The City’s Unified Development Code Section 5.2.3 states that neither a tree removal permit nor mitigation is required for removing trees on a parcel, tract or lot under one acre in size with an occupied residential structure, per the Arlington Zoning and UDC page. The ordinance that amended the section says the same: it does not apply to tracts or platted lots under one acre with an occupied residential structure, as shown in the City’s ordinance record.

In practice, a typical single-family lot in an established Arlington neighborhood falls under that exemption. A homeowner with a half-acre lot and a house on it generally does not need a stand-alone permit to remove a large pecan.

The exemption does not cover everything, so check these before you cut:

  • Lots of one acre or more. Residential developments over one acre must preserve a minimum of 35 percent of existing protected caliper inches, according to the same ordinance record. Large estates and acreage need a closer look.
  • Vacant lots. The exemption speaks of an occupied residential structure. An empty lot is not that.
  • Shared trees. The City’s Urban Forestry page says trees on a property boundary need approval from both owners before removal.
  • City property and rights-of-way. Trees on City land go through the Parks and Recreation Department, which the permit application lists at 817-459-5474. That includes the strip between the sidewalk and the street if it is City right-of-way.
  • Other overlays and private rules. An HOA may restrict removal even where the City does not. Our guide to HOA tree removal rules in Texas covers the paperwork those associations tend to ask for.

Dead, dying, diseased and hazardous trees

A tree that is dying is treated differently. According to the Tree Removal Permit Application, removing diseased, dying or dead trees, or trees on the prohibited plant list, does not need a tree removal permit but does require notifying the Zoning Administrator. Section 5.2.3 adds that notification and approval is not required for diseased, dying or dead trees on tracts under one acre with an occupied residential structure, per the City’s UDC chapter.

The same section exempts several other situations:

  • Trees removed in a dedicated right-of-way by a public utility.
  • Park maintenance on City-owned property.
  • Removal of a tree that disrupted a public utility service or presents a danger to the public due to catastrophe.
  • Any species on the City’s prohibited plant list.
  • Property owned by the City of Arlington at the National Airport.

Two practical points follow. First, the City’s Urban Forestry page says Code Compliance enforces removal of hazardous trees on private property, so a leaning, cracked or dead tree is something the City can require you to deal with. Second, “dead” and “dying” are findings of fact. If the tree is on a lot that needs notification, the Zoning Administrator is going to want a reason. A written assessment from an ISA Certified Arborist gives you a record of species, trunk size, defects and decay. Our tree risk assessment guide explains what that evaluation looks at, and the levels of risk assessment explains when a more detailed one makes sense.

How to apply and what it costs

For questions on how to apply, the City directs people to Plan.Dev@arlingtontx.gov on its Zoning and UDC page. The application form, dated 2014, asks for:

  1. The completed application form.
  2. A site plan showing lot boundaries, the building footprint and the approximate location of the trees to be removed.
  3. A landscape plan showing new trees, if you plan to replace them.
  4. The Tree Removal Permit Review Fee.

Because the form is dated, confirm with the City that it is the current version before you submit.

The City’s Planning and Development Services fee schedule effective October 1, 2025 lists these amounts:

ItemFee
Tree removal permit (not with a building permit)$10.00 per tree, minimum $30.00, maximum $150.00
Landscape review, site up to 5 acres$230.00
Landscape review, over 5 up to 20 acres$400.00
Landscape review, over 20 acres$600.00
Tree preservation plan review$400.00
Tree replacement$200.00 per caliper inch
Unauthorized tree removal$600.00 per caliper inch

Fee schedules are revised, so check the current version for the year you apply.

A worked example

Say you own a one-and-a-half-acre property in Arlington and want to remove three healthy live oaks of 8, 10 and 12 inches. The permit itself would be $10 per tree, so the $30 minimum applies. Mitigation is the larger cost. Under the application’s options you can replace removed trees one for one, on-site or off-site, or pay $100 per inch into the Reforestation Fund. Section 5.2.3, however, says that for trees six caliper inches or greater, or Cross Timbers oaks three caliper inches or greater, mitigation is paid into the Reforestation Fund at the Tree Replacement fee in the current schedule. On the current schedule that is $200 per caliper inch, so the 30 caliper inches in this example would be $6,000. The older $100 figure on the 2014 form is a reminder to read the current code and fee schedule, not the form alone.

This is an illustration of how the numbers combine, not a quote for any property. The City decides what applies to your site.

What mitigation means

Mitigation is how the City makes up for canopy you remove. The application describes two methods: replacing removed or affected trees on-site or off-site at a ratio of 1 to 1, or paying into the Reforestation Fund. The UDC chapter makes the payment route the rule for trees six caliper inches or greater. If you want to understand how replacement planting works in North Texas, our articles on tree mitigation planning and on tree mitigation in Dallas walk through the process. Mitigation is one of the services we offer.

Builders and developers face a heavier version of this. Section 5.2.3 applies to all types of development, including non-structural improvements such as parking lots, site layouts, landscape setbacks and buffer yards. A Preservation Plan is due when you apply for a planned development, plat, site plan or building permit, whichever comes first. For non-residential development, tree points are calculated for trees six inches or greater in caliper, per the City’s UDC page. Protecting trees during construction is far cheaper than paying to replace them afterward.

What happens if you cut without approval

Removing a regulated tree without approval is where the money gets serious. The permit application says violations may be $2,000 per offense for each day the violation continues. The fee schedule separately sets an unauthorized tree removal fee of $600 per caliper inch, effective April 1, 2025.

On the example above, three oaks totaling 30 caliper inches would carry $18,000 at that unauthorized rate, before any other penalty. A permit and a plan cost a fraction of that. If you are unsure whether a tree is regulated, ask before the saw comes out. A felled tree cannot be put back.

Collin County: do Arlington’s rules apply to you?

No. Arlington is in Tarrant County, and its Unified Development Code applies inside Arlington’s city limits. If your property is in Plano, McKinney, Frisco, Allen, Wylie, Murphy, Richardson’s Collin side or any other Collin County city, that city’s ordinances govern, and some of them differ a great deal from Arlington’s on size thresholds, species lists and fees. Properties outside any city limits follow different rules again.

Here is a short routine for a Collin County owner:

  1. Confirm your jurisdiction. Look at your tax or utility bill. Your mailing city is not always your taxing or regulating city.
  2. Search your city’s code. Look for terms like “tree preservation,” “tree removal” and “landscape.” Many cities put them in their zoning or development code.
  3. Call the planning or development services desk. Give the address, the species and the trunk diameter at 4.5 feet, and ask if a permit or mitigation applies.
  4. Check your HOA documents. Private covenants can be stricter than the city.
  5. Ask about utilities and easements. Trees under power lines or in easements follow different rules.

Our overview of tree removal permits in Texas explains how these requirements typically work across the state so you know what to ask.

Where a certified arborist helps

Permit rules turn on facts about the tree: species, trunk diameter, condition, location and whether it is dead, dying or hazardous. Those are arborist questions. We are ISA Certified Arborists, and our services include tree surveys, tree mitigation, tree health assessments and construction protection. Our tree health assessment guide shows what an assessment covers.

When a removal is approved or exempt, the next problem is doing it safely. Our Grapple Saw Truck, the first in North Texas, is designed to cut down on manual climbing and make removals safer and faster, and we also do crane-assisted removals. For tight yards, see our notes on confined yard tree removal and gate measurements, and for what happens on the day, our safe tree removal practices.

Our perspective

Most permit trouble we hear about does not start with a bad owner. It starts with a tree that nobody measured. Someone eyeballs a trunk, assumes it is under the threshold, and a day later it is stump and sawdust.

Our approach is to settle the facts first. An ISA Certified Arborist identifies the species, measures every trunk at the right height and records the condition of the tree. With that in hand, the question of permit, exemption or mitigation is a short conversation with the city, not a guess.

Then comes the part we are built for. Our Grapple Saw Truck lets us take large trees down with less climbing, and our crane work handles trees that sit over houses, pools and fences. If a tree is worth keeping, tree health care and construction protection are how we help it stay.

Rules differ from city to city, and we work across Dallas, Collin, Tarrant, Denton and the other DFW counties we serve. Whatever city your property is in, start with its rules and start with the tree.

Amy

Ready to remove or protect a tree

If you have a tree you are considering removing, or one you want to protect through a build, we can assess it, put the findings in writing and carry out the work. See our tree trimming and removal services or contact us through Texas Tree Transformations. After a storm or when a tree is an immediate danger, our emergency tree service is the place to start.

Texas Tree Transformations

FAQ

Do I need a permit to cut down a tree in my yard in Arlington?

Often not. The City’s code says no permit or mitigation is required on a lot under one acre with an occupied residential structure. On larger lots, vacant lots or shared boundary trees, a permit may be required for trees 6 inches or more in diameter, so confirm with the City first.

Do I need a permit to cut down a tree in Texas?

There is no single statewide answer. Most tree rules in Texas come from cities and from private covenants such as HOA rules. Check your own city’s code and your neighborhood documents before cutting.

Can I remove a dead tree in Arlington without a permit?

Dead, dying or diseased trees do not need a tree removal permit, but the City’s application says the Zoning Administrator must be notified. The UDC chapter says that notification is not required on a tract under one acre with an occupied residential structure.

Does the City of Arlington remove trees on my property?

Not as routine service. The City’s Urban Forestry page says Code Compliance enforces removal of hazardous trees on private property, which makes the owner responsible for the tree. Trees on City property and rights-of-way go through Parks and Recreation.

I live in Collin County. Does this permit apply to me?

No. Arlington’s permit applies within Arlington. Contact the planning or development services office of the city where your property sits, and review your HOA rules.

Sources

Scroll to Top